How to Configure Rheingold ISTA Work with K+DCAN Cable

You are here:
Estimated reading time: 1 min

How
to Configure Rheingold ISTA Work with K+DCAN Cable
Preparations

  • 2022.08 BMW Rheingold ISTA BMW Software
    4.36.40 4.23.14 ISTA-P 3.70 Free
    Download
  • How To Install BMW Rheingold ISTA BMW Software
  • How to Use BMW Rheingold ISTA BMW Software
    to Do Programming and Coding
  • How to Configure Rheingold ISTA Work with K+DCAN Cable
    Procedures

  • Plug your BMW Inpa k dcan
    cable
    and install drivers. For FTDI based cables use
    latest drivers
  • Open “Device Manager”, then USB Serial Port properties,
    go to “Port Settings” tab and click “Advanced”. Change
    port number to “COM9” and latency timer to “1”. Confirm
    configuration via “OK” button
  • Open C:EDIABASBINEDIABAS.INI with Notepad and check for
    “Interface = STD:OBD”. In TCP settings set “Port =
    6801”
  • Open C:EDIABASBINOBD.INI with Notepad and check for
    “Port=Com9”
  • Connect car with BMW Inpa k dcan
    cable
    to PC
  • Now run BMW Rheingold ISTA using shortcut in start menu and wait
    until it boots, then press settings button
  • Select “VCI Config” tab and “Ediabas standard
    settings (ediabas.ini)”, then “OK”
  • Go “Operations”, then “Read Out Vehicle Data”
    and “Complete Identification”
  • Tags:
    Was this article helpful?
    Dislike 0
    Views: 57
    Previous: BMW E39 EWS & CAS Module Coding by NCS Expert
    Next: How to Get 1B File from BMW Exx CIC without ICOM Interface