How to use Xentry to reprogramming engine ECU for FUSO truck

You are here:
Estimated reading time: < 1 min

When the ECU is replaced with a new or used one, you can use the previous coding parameters by downloading the ECU data from the FRN and then executing “Control unit replacement”.In this instruction will show you guide on how to use Xentry to reprogramming engine ECU for FUSO truck.

Related Contents:
Benz Xentry OpenShell.XDOS 2023 Free Download
How to Install Benz Xentry 2023.03 Diagnostic Software

Procedures:
After truck identification,then access diagnostic to select “Adaptions”
Then select “Initial startup” at left side menu and select “Control unit replacement”
Before continuing,please finish below steps:
Switch off ignition and replace control unit A4 [U01] (Combustion engine Control unit)

If only the ECU software needs to be updated, download the ECU data from the FRN and then execute “Reprogramming”. After completing software rewriting, execute the resetting of code entry.
Select “Reprogramming”

Was this article helpful?
Dislike 0
Views: 1
Previous: DIMSport Holdim family is growing with GLF TURBINE SRL acquisition
Next: IM608 JVCI J2534 Driver for OEM Software