Porsche Macan GTS Height Calibration by Launch X431 Pro Mini

You are here:
Estimated reading time: 2 min

Porsche Macan GTS Height Calibration by Launch X431 Pro Mini

I have successfully lowered my Macan GTS with a Launch  X431 Pro Mini obd2 diagnostic scanner running (Porsche V24.05 software).

the Process is very straightforward – there are many manuals on height calibration using PIWIS and those principles are also valid here.
I would advise not to use the values I have set as your Macan may be different and its always best to measure on your own

1. Plug the VCI into your Macan and connect to your launch x431

2. Start your Macan (for this to work for me my car was running)

3. Set your vehicle type and navigate to the coding section

4. Select Level Control > Code/Brush Hiding > Brush Hidden/Modified

5. Select Front Left Heigh Calibration

6. Add desired lowered amount to the value shown (ie: value + lowered amount in mm = new value )
my default value was 456 I wanted to lower the front 25mm so my new value to input is 481

7. Write your new value and go back to the previous menu

8. Select Front Right Height Calibration

9. Add desired lowered amount to the value shown (ie: value + lowered amount in mm = new value )
my default value was 445 I wanted to lower the front 25mm so my new value to input is 470

10. Write your new value and go back to the previous menu

11. Select Rear Left Height Calibration

12. Add desired lowered amount to the value shown (ie: value + lowered amount in mm = new value )
my default value was 439 I wanted to lower the back 20mm so my new value to input is 459

13. Write your new value and go back to the previous menu

14. Select Rear Right Height Calibration

15. Add desired lowered amount to the value shown (ie: value + lowered amount in mm = new value )
my default value was 434 I wanted to lower the back 20mm so my new value to input is 454

16. Write your new value and go back to the previous menu

17. Select Save Calibration

18. Set the Value to YES (The default value is already yes but we need to set it again to reinitiate the height change)

19. Write your new value – you will get a temporary suspension failure warning as it sets the module to your new values.

20. shut your Macan off for a few minutes and start it back up. go for a short drive around the block to make sure everything is settled.

21. Measure your height from the center cap to the fender and make sure the drop is where you want it.

22. Repeat for any fine-tuning

23. Step back and admire the stance

24. Order yourself some wheel spacers!

Low Mode Post-Drop:

Was this article helpful?
Dislike 0
Views: 16
Previous: Autel VVDI or ACDP to Read Porsche BCM 5M48H 2M25J
Next: 2015 Dodge SAS Calibration via Autel MaxiCOM MK908P